Er3+单掺、Er3+/Yb3+共掺杂Ca12Al14O32F2的 制备及上转换发光性质

利用高温固相法成功制备了Er~(3+)单掺、Er~(3+)/Yb~(3+)共掺杂Ca_(12)Al_(14)O_(32)F_2上转换发光样品。在980 nm激光激发下,Er~(3+)单掺和Er~(3+)/Yb~(3+)共掺杂样品均呈现出较强的绿光(528,549 nm)和较弱的红光(655 nm)发射,分别归因于Er~(3+)离子的~2H_(11/2),~4S_(3/2)→~4I_(15/2)和~4F_(9/2)→~4I_(15/2)能级跃迁。随着Er离子浓度的增加,单掺杂样品上转换发光强度先增大后减小,最佳掺杂浓度为0.8%。共掺杂Yb~(3+)后,Er~(3+)的发光强度明显增大。还原气氛下合成的样品上转换发光强度增大约两倍,可能和笼中阴离子基团变化有关。发光强度和激发光功率的关系表明所得上转换发射为双光子吸收过程,借助Er~(3+)-Yb~(3+)体系能级结构详细讨论了上转换发射的跃迁机制。     

HFIP-Functionalized Co3O4 Micro-Nano-Octahedra/rGO as a Double-Layer Sensing Material for Chemical Warfare Agents

Semiconductor metal oxides (SMO)-based gas-sensing materials suffer from insufficient detection of a specific target gas. Reliable selectivity, high sensitivity, and rapid response–recovery times under various working conditions are the main requirements for optimal gas sensors. Chemical warfare agents (CWA) such as sarin are fatal inhibitors of acetylcholinesterase in the nerve system. So, sensing materials with high sensitivity and selectivity toward CWA are urgently needed. Herein, micro-nano octahedral Co₃O₄ functionalized with hexafluoroisopropanol (HFIP) were deposited on a layer of reduced graphene oxide (rGO) as a double-layer sensing materials. The Co₃O₄ micro-nano octahedra were synthesized by direct growth from electrospun fiber templates calcined in ambient air. The double-layer rGO/Co₃O₄-HFIP sensing materials presented high selectivity toward DMMP (sarin agent simulant, dimethyl methyl phosphonate) versus rGO/Co₃O₄ and Co₃O₄ sensors after the exposure to various gases owing to hydrogen bonding between the DMMP molecules and Co₃O₄-HFIP. The rGO/Co₃O₄-HFIP sensors showed high stability with a response signal around 11.8 toward 0.5 ppm DMMP at 125 °C, and more than 75 % of the initial response was maintained under a saturated humid environment (85 % relative humidity). These results prove that these double-layer inorganic–organic composite sensing materials are excellent candidates to serve as optimal gas-sensing materials.     

Novel thionin-functionalised core shell magnetic nanoparticles for dispersive solid-phase extraction of Hg(II) in food and water samples

To develop an accurate and precise method for separation and pre-concentration of Hg(II), a novel thionin functionalised core shell structure magnetic material has been prepared and characterised. The extraction ability of the material was evaluated by magnetic solid-phase extraction coupled with inductively coupled plasma mass spectrometry determination of Hg(II) in food and water samples. Combining the advantages of magnetic separation with selective extraction of thionin towards Hg(II), the material exhibits enhanced enrich selectivity and efficiency for Hg(II). The experimental parameters influencing Hg(II) extraction efficiency, including pH of the aqueous solution, the dosage of the adsorbent, extraction time and sample volume, were systematically investigated. Under the optimised conditions, concentration of Hg(II) at 1.0 μg L^?1 can be successfully enriched by the material without the interference of the common co-existing ions. The enrichment factor and adsorption capacity were 250 and 75.2 mg g^?1, and precise of the method was confirmed by analysing the spiked food, water samples and standard water reference samples with the recoveries of 92.5–101.8%.     

Synthesis of boronic acid‐functionalized poly(glycerol‐oligoγ‐butyrolactone): Nano‐networks for efficient electrochemical sensing of biosystems

Despite the outstanding properties of hyperbranched polyglycerols such as biocompatibility and multifunctionality, enough attention has not been paid to the synthesis of their functional copolymers. This problem has limited the structural diversity of hyperbranched polyglycerols and hampers further developments and their practical usage. In this work, butyrolactone segments were incorporated into the backbone of polyglycerols by one‐pot ring‐opening copolymerization of a mixture of glycidol and γ‐butyrolactone in the presence of tin(II) 2‐ethylhexanoate. Poly(glycerol‐oligoγ‐butyrolactone)s were then crosslinked by 2,5‐thiophenediylbisboronic acid to obtain polymeric nanonetworks with 140 nm average size. Afterwards, the gold electrode was modified by the polymeric nano‐networks, and it was used for the determination of glucose, glycated hemoglobin, and Escherichia coli in phosphate buffer solution (pH = 9.0) through cyclic voltammetry and impedance spectroscopic. Taking advantage of the straightforward synthesis, cheap precursors and multifunctionality of poly(glycerol‐oligoγ‐butyrolactone)s, they could be used for real‐time sensing of a wide range of biosystems. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019, 57, 1430–1439     

Euphorbia polygonifolia extract assisted biosynthesis of Fe3O4@CuO nanoparticles: Applications in the removal of metronidazole,ciprofloxacin and cephalexin antibiotics from aqueous solutions under UV irradiation

In this study, a new, economical and green method was reported for synthesizing Fe₃O₄@CuO nanoparticles without adding any surfactants using Euphorbia polygonifolia extract as a renewable, mild and safe reducing agent and effective stabilizer. The green synthesized NPs were analyzed by various methods such as XRD, FESEM, FT-IR, EDS, VSM, UV–visible, DRS, BET and TGA-DTA. Based on the BET analysis, the Fe₃O₄@CuO NP had a surface area of 69.20 m²/g. The FTIR analysis verified the existence of different functional groups of phytochemicals from Euphorbia polygonifolia extract which were accountable for the NPs formation. The catalytic performance of the catalyst for the degradation of metronidazole, ciprofloxacin and cephalexin antibiotics was examined in aqueous mediums at room temperature. The results showed an extraordinary catalytic performance, easy reusability and long-term stability of the composite for reducing antibiotic pollution. In this process, the effects of environmental conditions such as initial pH of the environment, initial concentration of antibiotics, the concentration of modified photocatalyst and reaction time were studied. According to the results, at the optimal conditions, the highest removal efficiency for metronidazole, ciprofloxacin and cephalexin antibiotics using Fe₃O₄@CuO nanoparticles, were 89%, 94%, and 96%, respectively. Also, it was observed that even after recycling, the NPs presents good nanocatalytic stability for the degradation of antibiotics. Using the NPs for five cycles did not significantly alter the photocatalyst efficiency, showing that the photocatalytic stability of the NPs was excellent.     

Sulfonic acid-functionalized Fe3O4-supported magnetized graphene oxide quantum dots: A novel organic-inorganic nanocomposite as an efficient and recyclable nanocatalyst for the synthesis of dihydropyrano[2,3-c]pyrazole and 4H-chromene derivatives

In this research, the main emphasis has been focused on the preparation of a novel Fe₃O₄-supported propane-1-sulfonic acid-grafted graphene oxide quantum dots (Fe₃O₄@GOQD-O-(propane-1-sulfonic acid)) that it was readily synthesized via a five-step procedure as a hitherto unreported magnetic nanocatalyst. This newly prepared Fe₃O₄@GOQD-O-(propane-1-sulfonic acid) nanocomposite was structurally well-established by different analytical techniques including Fourier transform infrared (FT-IR), X-ray diffraction (XRD), energy-dispersive X-ray (EDX), thermal gravimetric analysis (TGA), field emission gun-scanning electron microscope (FESEM), high-resolution transmission electron microscopy (HRTEM) and vibrating sample magnetometer (VSM) analyses. The high catalytic performance of this nanocomposite was exhibited in one-pot synthesis of dihydropyrano[2,3-c]pyrazole and 4H-chromene derivatives under mild conditions. Low reaction times, excellent yields of the products, benignity of the catalyst, easy reaction work-up and magnetic recyclability of the catalyst are the main advantages of the present protocol. Also, our research indicated that the Fe₃O₄@GOQD-O-(propane-1-sulfonic acid) could be reused up to five times without considerable loss of catalytic activity.     

基于碳化硅衬底的宽禁带半导体外延

宽禁带半导体具备禁带宽度大、电子饱和飘移速度高、击穿场强大等优势,是制备高功率密度、高频率、低损耗电子器件的理想材料。碳化硅(SiC)材料具有热导率高、化学稳定性好、耐高温等优点,在SiC衬底上外延宽禁带半导体材料,对充分发挥宽禁带半导体材料的优势,并提升宽禁带半导体电子器件的性能具有重要意义。得益于SiC衬底质量持续提升及成本不断降低,基于SiC衬底的宽禁带半导体电子市场占比呈现逐年增加的态势。在SiC衬底上外延生长高质量的宽禁带半导体材料是提高宽禁带半导体电子器件性能及可靠性的关键瓶颈。本文综述了近年来国内外研究者们在SiC衬底上外延SiC、氮化镓(GaN)、氧化镓(Ga₂O₃)所取得的研究进展,并展望了SiC衬底上宽禁带半导体外延的发展及应用前景。     

Mechanism and Stereoselectivity of the Elementometalation Process of Activated Alkyne RCCR(RCO2Me) by Cp2TaH3

The elementometalation process is a fundamental chemical step in several catalytic cycles. In this work, density functional theory computations have elucidated the detailed elementometalation mechanism of activated alkyne RCCR(RCO₂Me) by Cp₂TaH₃ and rationalized the selectivity in experimental findings. The calculated results show that in the formation process of (E)-olefin monohydride((E)-Pro), the Gibbs free energy barrier is low and the entire reaction is spontaneous and exothermic; thus, (E)-Pro can be formed easily. The formation of (Z)-η²-olefin monohydride complex ((Z)-Pro) is difficult due to its high Gibbs free energy barrier. The formation process (E)-Pro consists of the following five steps: hydride H1-shift, conformational isomerism 1, hydride H2-shift, conformational isomerism 2, and olefin coordination process. Topological analysis shows that there is a five-membered ring plane structure in the reaction pathway and that the final product (E)-Pro belongs to a typical η²-olefin monohydride complex. Our calculated results provide an explanation for experimental observations and useful insights for further development of olefin functionalization. © 2019 Wiley Periodicals, Inc.     

Synthesis,crystal structure and conformational analysis of an unexpected [1,5]dithiocine product of aminopyridine and thiovanillin

The condensation reaction of 2‐mercapto‐3‐methoxybenzaldehyde with 3‐aminopyridine afforded an unexpected N‐alkylated [1,5]dithiocine instead of the N‐salicylideneaniline. The proposed mechanism for this condensation involves a strong intramolecular hydrogen bond between the thiol and the amine groups, leading to a second condensation. The corresponding product, i.e. 4,10‐dimethoxy‐13‐(pyridin‐3‐yl)‐6H,12H‐6,12‐epiminodibenzo[b,f][1,5]dithiocine methanol 0.463‐solvate, C₂₁H₁₈N₂O₂S₂·0.463CH₃OH, was characterized by single‐crystal X‐ray diffraction analysis. The supramolecular structure shows π–π stacking and S…S interactions in the crystal packing. Within the asymmetric unit, two geometries of the N atom are observed. Although a planar geometry should be expected, a pyramidal one is observed due to the crystal packing. The presence of the two geometries was further supported by density functional theory (DFT) calculations that show an electronic energy difference of less than 2 kJ mol^?1 between the two conformers.     

Lump and interaction solutions to the (3+1)-dimensional Burgers equation

The(3+1)-dimensional Burgers equation, which describes nonlinear waves in turbulence and the interface dynamics,is considered. Two types of semi-rational solutions, namely, the lump–kink solution and the lump–two kinks solution, are constructed from the quadratic function ansatz. Some interesting features of interactions between lumps and other solitons are revealed analytically and shown graphically, such as fusion and fission processes.